Entire Combination Meter Does Not Operate

METER: METER / GAUGE SYSTEM: Entire Combination Meter does not Operate

Entire Combination Meter does not Operate

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK WIRE HARNESS (COMBINATION METER - BATTERY AND BODY GROUND)




(a) Disconnect the K31 meter connector.
(b) Measure the resistance and voltage of the wire harness side connector.
Standard resistance:
Standard voltage










NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
2. CHECK COMBINATION METER (AUTOMATIC LIGHT CONTROL SENSOR SYSTEM)




(a) Disconnect the K31 meter connector.
(b) Measure the resistance of the wire harness side connector.
Standard resistance:






OK -- REPLACE COMBINATION METER
NG -- Continue to next step.
3. CHECK WIRE HARNESS (AUTOMATIC LIGHT CONTROL SENSOR - COMBINATION METER)




(a) Disconnect the V34 sensor connector.
(b) Disconnect the K31 meter connector.
(c) Measure the resistance of the wire harness side connector.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE AUTOMATIC LIGHT CONTROL SENSOR