Hazard Warning Switch Circuit

LIGHTING: LIGHTING SYSTEM: Hazard Warning Switch Circuit

Hazard Warning Switch Circuit

DESCRIPTION

The hazard warning switch sends a signal to the turn signal flasher.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. INSPECT MULTI-DISPLAY (HAZARD WARNING SWITCH)




(a) Disconnect the K46 display connector.
(b) Measure the resistance of the multi-display connector.
Standard resistance:






NG -- REPLACE MULTI-DISPLAY
OK -- Continue to next step.
2. CHECK WIRE HARNESS (MULTI-DISPLAY - TURN SIGNAL FLASHER AND BODY GROUND)




(a) Disconnect the K46 display connectors.
(b) Disconnect the K25 flasher connector.
(c) Measure the resistance of the wire harness side connectors.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE