Installation

BRAKE CONTROL: YAW RATE AND ACCELERATION SENSOR: INSTALLATION

INSTALLATION

1. INSTALL YAW RATE SENSOR





(a) Install the sensor with the 2 bolts.
Torque: 15 Nm (153 kgf-cm, 11ft-lbf)
- Do not damage the sensor.
- Make sure that the sensor is installed securely.

(b) Install the 2 wire harness clamps.
(c) Connect the sensor connector.
2. INSTALL NO. 1 CONSOLE BOX DUCT





(a) Install the No. 1 duct with the clip.
3. INSTALL NO. 2 CONSOLE BOX DUCT





(a) Install the No. 2 duct with the 2 clips.
4. INSTALL CONSOLE BOX Installation
5. INSTALL CONSOLE BOX REGISTER ASSEMBLY Installation
6. INSTALL CONSOLE BOX PLATE Installation
7. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation
8. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation
9. INSTALL CONSOLE UPPER PANEL ASSEMBLY Installation
10. INSTALL FRONT CONSOLE UPPER PANEL GARNISH Installation
11. PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION
(a) Perform the yaw rate sensor zero point calibration Programming and Relearning.
12. CHECK YAW RATE SENSOR SIGNAL
(a) Check the yaw rate sensor signal Test Mode Procedure.