Removal

2GR-FSE EMISSION CONTROL: FUEL TANK PRESSURE SENSOR: REMOVAL

REMOVAL

1. DISCHARGE FUEL SYSTEM PRESSURE Removal
2. DISCONNECT CABLE FROM BATTERY NEGATIVE TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

3. REMOVE SERVICE PLUG GRIP Removal
4. REMOVE FUEL TANK ASSEMBLY
(a) Remove the fuel tank from the vehicle Removal.
5. REMOVE NO. 3 FUEL TANK PROTECTOR





(a) Release the lock and then turn the protector and remove it.
6. REMOVE FUEL TANK PRESSURE SENSOR
(a) Disconnect the pressure sensor connector.





(b) Remove the joint clip and pressure sensor.
- Before removing the tube joint clip, check for foreign matter around the clip. Clean if necessary.
- Keep the O-ring free of foreign matter, as it becomes contaminated easily.
- Do not use any tools in this procedure.
- Be careful not to damage the clip. If the clip is damaged, replace it.

7. REMOVE FUEL TANK VENT TUBE SET PLATE





(a) Remove the 4 screws, vent tube set plate, support plate and gasket.