Body - Paint Staining Under Rapgard(R)
L-SB-0014-08March 20, 2008
Paint Stains Under Rapgard (TM)
Service Category
Vehicle Exterior
Section
Paint/Coatings
Market
USA
Applicability
Introduction
On some vehicles when Rapgard(TM) is removed the paint may have a stained appearance. These stains appear to be under the clear coat. The stain patterns are usually under wrinkles in the Rapgard TM These wrinkles sometimes trap water and cause the paint to stain from the trapped moisture especially on horizontal surfaces such as the hood roof and trunk. Stains can be removed by heating the stained surface to remove the trapped moisture. Use the following procedure to address this concern.
Warranty Information
APPLICABLE WARRANTY
^ This repair is covered under the Lexus Comprehensive Warranty. This warranty is in effect for 48 months or 50,000 miles, whichever occurs first, from the vehicle's in-service date.
Required Tools & Equipment
Repair Procedure
1. Use aluminum foil or damp cloth to cover plastic/rubber parts that are near the stain.
2. Apply heat to the stain using an infrared lamp or heat gun.
NOTE
Apply heat for 5 - 10 minutes at 158°F - 176°F (70°C - 80°C). Do NOT allow the surface to become hotter than 176°F (80°C). Measure the temperature with a thermometer.
3. After applying heat for 5 minutes examine the area to determine if the stain has been removed. If the stain still exists continue to apply heat and re-examine the stain 5 minutes later.