Reassembly

PARKING BRAKE: PARKING BRAKE ASSEMBLY: REASSEMBLY

REASSEMBLY

1. INSTALL PARKING BRAKE ANCHOR BLOCK





(a) Install the parking brake anchor block and cable support bracket with 2 nuts.
Torque: 76 Nm (775 kgf-cm, 56 ft-lbf)
(b) Install the rear axle hub and bearing assembly Installation.
2. APPLY HIGH TEMPERATURE GREASE
(a) Apply a thin layer of high temperature grease to the area where the parking brake plate contacts the parking brake shoe Removal and Replacement.
3. INSTALL PARKING BRAKE SHOE LEVER





(a) Apply a thin layer of high temperature grease to the area where the parking brake shoe lever contacts the parking brake anchor block.
(b) Install the parking brake shoe lever to the parking brake cable assembly.
NOTE:
Take care to install the correct parking brake shoe lever because the direction of the pin is different between left and right.

4. INSTALL NO. 2 PARKING BRAKE SHOE ASSEMBLY





(a) Using SST, install the No. 2 parking brake shoe assembly with the No. 1 shoe hold down spring cup, No. 1 compression spring and No. 1 shoe hold down spring pin.
SST: 09718-00010
HINT:
Use the service hole to retain the No. 2 shoe hold down spring pin with your finger.

5. INSTALL NO. 1 PARKING BRAKE SHOE ASSEMBLY





(a) Using SST, install the No. 1 parking brake shoe assembly with the No. 1 shoe hold down spring cup, No. 1 compression spring and No. 1 shoe hold down spring pin.
SST: 09718-00010
HINT:
Use the service hole to retain the No. 1 shoe hold down spring pin with your finger.

6. INSTALL PARKING BRAKE SHOE ADJUSTING SCREW SET





(a) Apply high temperature grease to the thread and all joining areas of the parking brake shoe adjusting screw set.





(b) Install the parking brake shoe adjusting screw set.
7. INSTALL NO. 1 PARKING BRAKE SHOE RETURN SPRING





(a) Install the No. 1 parking brake shoe return spring.
8. INSTALL NO. 2 PARKING BRAKE SHOE RETURN SPRING





(a) Install the No. 2 parking brake shoe return spring.
9. CHECK PARKING BRAKE INSTALLATION
(a) Make sure that all the parts are installed properly.
If necessary, reinstall properly.





10. INSTALL REAR DISC
(a) Align the matchmarks on the rear disc and rear axle hub.
11. ADJUST PARKING BRAKE SHOE CLEARANCE Adjustments
12. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY





(a) Install the rear disc brake caliper assembly with the 2 bolts and 2 new No. 1 caliper plates.
Torque: 50 Nm (510 kgf-cm, 37 ft-lbf)
- Do not twist the brake hose.
- Make sure that the bolts are free from damage and foreign matter.
- Do not overtighten the bolts.

13. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
14. INSPECT PARKING BRAKE PEDAL TRAVEL (for Automatic Transmission) Adjustments
15. ADJUST PARKING BRAKE PEDAL TRAVEL (for Automatic Transmission) Adjustments
16. INSPECT PARKING BRAKE LEVER TRAVEL (for Manual Transmission) Adjustments
17. ADJUST PARKING BRAKE LEVER TRAVEL (for Manual Transmission) Adjustments