Removal

METER: COMBINATION METER: REMOVAL

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

2. REMOVE STEERING COLUMN COVER (for Manual Tilt and Manual Telescopic Steering Column) Removal
3. REMOVE STEERING COLUMN COVER (for Power Tilt and Power Telescopic Steering Column) Removal
4. REMOVE FRONT DOOR SCUFF PLATE LH (w/o Illumination) Removal
5. REMOVE FRONT DOOR SCUFF PLATE LH (w/ Illumination) Removal
6. REMOVE FRONT DOOR OPENING TRIM COVER LH Removal
7. REMOVE SIDE INSTRUMENT PANEL LH Removal
8. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Removal
9. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY





(a) Disengage the 2 clips.





(b) Remove the 2 screws and remove the instrument cluster finish panel sub-assembly.
10. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY Removal
11. REMOVE COMBINATION METER ASSEMBLY





(a) Attach protective tape to the position indicated in the illustration.





(b) Using a screwdriver, disengage the claw.
HINT:
Tape the screwdriver tip before use.





(c) Using a screwdriver, disengage the claw, pull out the combination meter assembly.
HINT:
Tape the screwdriver tip before use.





(d) Disconnect the connectors and remove the combination meter assembly as shown in the illustration.
NOTE:
Do not damage the instrument panel safety pad or combination meter assembly when removing the combination meter assembly.

12. REMOVE COMBINATION METER GLASS





(a) Disengage the 9 claws and remove the combination meter glass.