Interior Light Switch Signal Circuit

LIGHTING: LIGHTING SYSTEM: Interior Light Switch Signal Circuit

Interior Light Switch Signal Circuit

DESCRIPTION

The main body ECU RH receives information on the front interior light switch (marked ON/OFF).
The main body ECU LH receives information on the front interior light switch (marked DOOR).
According to the position of each switch, the main body ECU RH controls the turning on and off of the interior lights, and the main body ECU LH controls the illuminated entry system.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. READ VALUE USING TECHSTREAM
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / (desired system) / Data List.
(e) Read the display on the Techstream.

Body (Main Body ECU RH)





Body No. 3 (Main Body ECU LH)





OK:
Switch condition can be displayed.
Result:






C -- INSPECT OVERHEAD J/B
B -- INSPECT OVERHEAD J/B
A -- INSPECT OVERHEAD J/B
D -- PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
2. INSPECT OVERHEAD J/B




(a) Remove the overhead J/B.
(b) Measure the resistance according to the value(s) in the table.
Standard resistance:






NG -- REPLACE OVERHEAD J/B
OK -- Continue to next step.
3. CHECK HARNESS AND CONNECTOR (OVERHEAD J/B - MAIN BODY ECU RH)




(a) Disconnect the R5 overhead J/B connector.
(b) Disconnect the J75 main body ECU RH connector.
(c) Measure the resistance according to the value(s) in the table.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE MAIN BODY ECU LH (COWL SIDE J/B LH)
4. INSPECT OVERHEAD J/B




(a) Remove the overhead J/B.
(b) Measure the resistance according to the value(s) in the table.
Standard resistance:






NG -- REPLACE OVERHEAD J/B
OK -- Continue to next step.
5. CHECK HARNESS AND CONNECTOR (OVERHEAD J/B - MAIN BODY ECU LH)




(a) Disconnect the R5 overhead J/B connector.
(b) Disconnect the Q3 main body ECU LH connector.
(c) Measure the resistance according to the value(s) in the table.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE MAIN BODY ECU LH (COWL SIDE J/B LH)
6. INSPECT OVERHEAD J/B




(a) Remove the overhead J/B.
(b) Measure the resistance according to the value(s) in the table.
Standard resistance:






NG -- REPLACE OVERHEAD J/B
OK -- REPAIR OR REPLACE HARNESS OR CONNECTOR (OVERHEAD J/B GROUND CIRCUIT)