Registration

SUPPLEMENTAL RESTRAINT SYSTEM: OCCUPANT CLASSIFICATION SYSTEM: REGISTRATION

REGISTRATION

1. REGISTRATION
NOTICE:
- If any DTCs related to the occupant classification ECU are output, troubleshoot those DTCs by referring to the DIAGNOSTIC TROUBLE CODE CHART.
- When ECU data saving or loading operations cannot be performed, replace the front seat cushion (with occupant classification ECU and occupant detection sensor).
HINT:
- When the occupant classification ECU is replaced, the previous ECU data must be saved in the Techstream and loaded into the new ECU by following the flowchart below.
- Until the data from the previous ECU are loaded into the new occupant classification ECU, these data are not erased even when the Techstream is turned off.
- ECU EXCHANGE procedure (Before Exchange) describes the procedure to save the data in the Techstream from the occupant classification ECU which has been installed on the vehicle. ECU EXCHANGE procedure (After Exchange) describes the procedure to load the data from the previous ECU, stored in the Techstream, into the new ECU.

(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Store the occupant classification ECU data in the Techstream by following the prompts on the Techstream screen.
HINT:
If the ECU data cannot be stored in the Techstream, replace the front seat cushion (with occupant classification ECU and occupant detection sensor).

(d) Turn the engine switch on (IG).
(e) Disconnect the negative (-) terminal cable from the battery, and wait for at least 90 seconds.
(f) Front seat (for power seat)
(1) Replace the front seat cushion (with occupant classification ECU and occupant detection sensor) Disassembly.
(g) Front seat (for manual seat)
(1) Replace the front seat cushion (with occupant classification ECU and occupant detection sensor) Disassembly.
(h) Connect the negative (-) terminal cable to the battery.
(i) Turn the engine switch on (IG).
(j) Load the data from the previous ECU stored in the Techstream, into the newly installed ECU by following the prompts on the Techstream screen.
(k) Turn the engine switch off.
(l) Turn the engine switch on (IG).
(m) Clear the DTCs stored in the memory Reading and Clearing Diagnostic Trouble Codes.
HINT:
If DTCs are not cleared at this time, past DTCs will remain.