Television Display Screen is not Stabilized

AUDIO / VISUAL: REAR SEAT ENTERTAINMENT SYSTEM: Television Display Screen is not Stabilized

Television Display Screen is not Stabilized

INSPECTION PROCEDURE

PROCEDURE

1. CHECK MODE IN WHICH SCREEN IS NOT STABILIZED
(a) Check the mode in which the screen is not stabilized.

Result





D -- GO TO NAVIGATION DISPLAY APPEARS ON THE MULTI-DISPLAY, BUT DOES NOT APPEAR ON THE TELEVISION DISPLAY ASSEMBLY
C -- REPLACE RADIO RECEIVER
B -- CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE)
A -- Continue to next step.
2. CHECK NTSC/PAL SIGNAL (RSE IMAGE QUALITY ADJUSTMENT SCREEN)




(a) During the VTR image, check if the changing of the NTSC/PAL signal is normal by pressing the remote controller's DISPLAY switch, entering the RSE image adjustment screen, and pressing the PAL VIDEO button.
OK:
Returned to normal after pressing PAL VIDEO button.
NG -- CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE)
OK -- END
3. CHECK VEHICLE SIGNAL (DISPLAY CHECK MODE)




(a) Enter the "Display Check" mode (Vehicle Signal Check Mode) Display Check Mode.
(b) Check that the display changes between ON and OFF according to the light control switch operation.
OK:





HINT: This display is updated once per second. As a result, it is normal for the display to lag behind the actual change in the switch.

NG -- GO TO DISPLAY DOES NOT DIM WHEN LIGHT CONTROL SWITCH IS TURNED ON
OK -- PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE