Removal

NAVIGATION: DISPLAY AND NAVIGATION ASSEMBLY: REMOVAL

REMOVAL

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Removal
2. REMOVE BATTERY SERVICE HOLE COVER LH Removal
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
- After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal
5. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal
6. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY Removal
7. REMOVE NO. 3 BOX PANEL Removal
8. REMOVE REAR UPPER CONSOLE PANEL Removal
9. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY Removal
10. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET Removal
11. REMOVE DISPLAY AND NAVIGATION ASSEMBLY WITH BRACKET





(a) Remove the 2 bolts.





(b) With both hands, pull the bottom part of the display outward slightly.





(c) With your right hand holding the rear side of the display and your left hand holding the left side of the display, pull it outward slightly.





(d) With your left hand holding the rear side of the display and your right hand holding the right side of the display, pull it outward slightly.





(e) Repeat the 2 steps above several times to detach the 6 clips and pull out the display.
(f) Disconnect the connectors and remove the display.





12. REMOVE NO. 2 RADIO BRACKET
(a) Remove the 2 bolts and bracket.





13. REMOVE NO. 1 RADIO BRACKET
(a) Remove the 2 bolts and bracket.