Diagnosis Display Detailed Description

NAVIGATION: NAVIGATION SYSTEM (for DVD): DIAGNOSIS DISPLAY DETAILED DESCRIPTION

DIAGNOSIS DISPLAY DETAILED DESCRIPTION
HINT:
- This section contains a detailed description of displays within diagnostic mode.
- Illustrations may differ from the actual vehicle depending on the device settings and options. Therefore, some detailed areas may not be exactly the same as on the actual vehicle.

1. SYSTEM CHECK
(a) System Check Mode Screen

(1) Device Names and Hardware Address/*1
HINT:
- Registered device names are displayed.
- If a device name is unknown to the system, its physical address is shown instead.

(2) Check Result/*2
HINT: Result codes for all devices are displayed.

(3) Code Clear/*3

- Present DTCs are cleared.
- Press the "Code CLR" switch for 3 seconds.
(4) Memory Clear/*4

- Present and past DTCs and registered connected device names are cleared.
- Press the "Memory CLR" switch for 3 seconds.

(b) Diagnosis MENU Screen

HINT: Some items may be grayed out or not displayed, as the functions are different depending on the vehicle.

(c) Unit Check Mode Screen

Screen description

(d) LAN Monitor (Original) Screen

(1) Check Result/*
HINT: Check results of all the devices are displayed.

(e) LAN Monitor (Individual) Screen

Screen description

2. DISPLAY CHECK
(a) Vehicle Signal Check Mode Screen

Screen description

HINT:
- Only items sending a vehicle signal will be displayed.
- This screen is updated once per second when input signals to the vehicle are changed.

(b) Microphone & Voice Recognition

Screen Description:

HINT:
- The microphone input function is on at all times when this screen is displayed.
- While recording or playing, the switches other than the stop switch cannot be pushed.
- When no voice is recorded, the play switch cannot be pushed.
- Recording will stop after 5 seconds or by pushing the stop switch.

(c) CAN Connection Check Screen

Screen Description:

HINT:
- This function operates only for the systems connected to the CAN system.
- When the power switch is turned OFF, the bus lines are disconnected, or a malfunction occurs in the bus lines while the CAN connection check result is being displayed, the problem will be reflected on the screen in real time.

3. NAVIGATION CHECK
(a) Navigation Check Screen

HINT: Some items may be grayed out or not displayed, as the functions are different depending on the vehicle.

(b) GPS Information Screen

(1) Satellite information/*1
Information from a maximum of 12 satellites is displayed on the screen. This information includes the target GPS satellite number, elevation angle, direction, and signal level.
(2) Receiving condition/*2

DENSO model