Rear Door Closer RH Does Not Operate

ENGINE HOOD / DOOR: DOOR CLOSER SYSTEM: Rear Door Closer RH does not Operate

Rear Door Closer RH does not Operate

DESCRIPTION

The rear multiplex network door ECU RH receives rear door closer RH signals, and activates the rear door closer motor RH.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK POWER DOOR LOCK OPERATION
(a) Check the power door lock control function Power Door Lock Control System.
OK:
Each function of power door lock control system operates normally using master switch.
NG -- Go to POWER DOOR LOCK CONTROL SYSTEM
OK -- Continue to next step.
2.
CHECK HARNESS AND CONNECTOR (REAR MULTIPLEX NETWORK DOOR ECU RH - REAR DOOR CLOSER RH)




(a) Disconnect the O4 ECU connector.
(b) Disconnect the O9 closer connector.
(c) Measure the resistance according to the value(s) in the table below.
Standard resistance:






NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.
3. INSPECT REAR DOOR LOCK ASSEMBLY RH (REAR DOOR CLOSER RH)
(a) Remove the rear door lock RH Removal.




(b) Set the door closer to the half-latch position.
(c) Apply battery voltage to the lock motor connector and check the closer operation.
OK:






NG -- REPLACE REAR DOOR LOCK ASSEMBLY RH (REAR DOOR CLOSER RH)
OK -- Continue to next step.
4. CHECK REAR MULTIPLEX NETWORK DOOR ECU RH (OPERATION)
(a) Temporarily replace the rear door ECU RH with a new or normally functioning one Components.
(b) Check the door closer operation Component Tests and General Diagnostics.
OK:
Door closer operation is normal.
NG -- REPLACE REAR DOOR LOCK ASSEMBLY RH (REAR DOOR CLOSER RH)
OK -- END (REAR MULTIPLEX NETWORK DOOR ECU RH IS DEFECTIVE)