Camshaft, Lifters and Push Rods: Specifications
CAMSHAFT (for Bank 1)LH:
Install the camshaft housing, and install the 18 bolts in the order shown in the illustration.
for bolt A - Torque: 10 Nm (102 kgf-cm, 7ft-lbf)
except bolt A - Torque: 30 Nm (306 kgf-cm, 22ft-lbf)
- Do not start the engine for at least 2 hours after the installation.
- Make sure that the knock pin of the camshaft is positioned as shown in the illustration before installing the camshaft housing.
Tighten the 8 bolts in the order shown in the illustration.
Torque: 16 Nm (163 kgf-cm, 12ft-lbf)
CAMSHAFT (for Bank 2)
RH:
Install the camshaft housing, and install the 18 bolts in the order shown in the illustration.
for bolt A - Torque: 10 Nm (102 kgf-cm, 7ft-lbf)
except bolt A - Torque: 30 Nm (306 kgf-cm, 22ft-lbf)
- Do not start the engine for at least 2 hours after the installation.
- Make sure that the knock pin of the camshaft is positioned as shown in the illustration before installing the camshaft housing.
RH:
Tighten the 8 bolts in the order shown in the illustration.
Torque: 16 Nm (163 kgf-cm, 12ft-lbf)