Removal

L110F HYBRID VEHICLE CONTROL: HYBRID VEHICLE CONTROL ECU: REMOVAL

REMOVAL

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Removal
2. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire) Removal
3. REMOVE BATTERY SERVICE HOLE COVER LH Removal
4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
- After the power switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. Therefore, after turning the power switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

5. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY Removal
6. REMOVE ENGINE ROOM SIDE COVER LH Removal
7. REMOVE ENGINE ROOM ECU COVER Removal
8. REMOVE HYBRID VEHICLE CONTROL ECU





(a) Disconnect the 4 hybrid vehicle control ECU connectors.
(b) Remove the 2 nuts and hybrid vehicle control ECU.
9. REMOVE ECU BRACKET





(a) Remove the 4 screws and 2 ECU brackets.