Removal

POWER STEERING: POWER STEERING ECU: REMOVAL

REMOVAL

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY
2. REMOVE BATTERY SERVICE HOLE COVER LH Removal
3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTICE:
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
- After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.

4. REMOVE ENGINE ROOM SIDE COVER
(a) Remove the 4 clips and side cover.
5. REMOVE AIR CLEANER INLET COVER SUB-ASSEMBLY
(a) Remove the 5 clips and inlet cover.
6. REMOVE AIR CLEANER ASSEMBLY RH Removal
7. REMOVE NO. 1 INVERTER RESERVOIR BRACKET

(a) Remove the 2 nuts, and slide the inverter reservoir towards the engine.

(b) Remove the 2 bolts and bracket.
8. REMOVE POWER STEERING ECU

(a) Release the locks of ECU connectors A and B and disconnect the connectors.
(b) Disconnect the connector C from the ECU.