Installation

SUPPLEMENTAL RESTRAINT SYSTEM: FRONT AIRBAG SENSOR: INSTALLATION

INSTALLATION
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.

1. INSTALL FRONT AIRBAG SENSOR





(a) Check that the power switch is OFF.
(b) Check that the cable is disconnected from the battery negative (-) terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

(c) Connect the connector.
(d) Install the front airbag sensor with the 2 bolts.
Torque: 9.0 Nm (92 kgf-cm, 80in-lbf)
NOTICE:
- If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(e) Check that there is no looseness in the installation parts of the front airbag sensor.
2. INSTALL HEADLIGHT ASSEMBLY LH
(a) Install the headlight assembly LH (for LED headlight) Installation.
(b) Install the headlight assembly LH (for HID headlight) Installation.
3. CHECK SRS WARNING LIGHT Installation
4. ADJUST HEADLIGHT ASSEMBLY LH
(a) Adjust the headlight assembly LH (for LED headlight) Headlight Assembly (for LED Headlight).
(b) Adjust the headlight assembly LH (for HID headlight) Headlight Assembly (for HID Headlight).