Removal

SUPPLEMENTAL RESTRAINT SYSTEM: STEERING PAD: REMOVAL

REMOVAL

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Removal
2. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire) Removal
3. REMOVE BATTERY SERVICE HOLE COVER LH Removal
4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
NOTICE:
- After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
- When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

5. REMOVE SWITCH AND VOLUME CASE





(a) Using a screwdriver, detach the claw to remove the switch.
HINT: Tape the screwdriver tip before use.

6. REMOVE LOWER NO. 2 STEERING WHEEL COVER





(a) Using a screwdriver, detach the 2 claws and remove the No. 2 steering wheel cover.
HINT: Tape the screwdriver tip before use.

7. REMOVE STEERING PAD





(a) Using a T30 "TORX" socket wrench, loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.





(b) Pull out the steering pad from the steering wheel, as shown in the illustration. Then support the steering pad with one hand.
NOTICE:
When removing the steering pad, do not pull the airbag wire harness.

(c) Disconnect the horn connector.
(d) Disconnect the 2 connectors and remove the steering pad.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.