Torque Specifications

SERVICE SPECIFICATIONS: 2UR-FSE ENGINE MECHANICAL: TORQUE SPECIFICATIONS

TORQUE SPECIFICATIONS














Water pump (non-hybrid)






Bolt A - Torque: 20 Nm (204 kgf-cm, 15ft-lbf)
Bolt B - Torque: 23 Nm (235 kgf-cm, 17ft-lbf)
Bolt C - Torque: 47 Nm (479 kgf-cm, 35ft-lbf)

Water pump with motor assembly (hybrid) 22 Nm (224 kgf-cm, 16ft-lbf)

EXHAUST MANIFOLD SUB-ASSEMBLY LH






Torque: 21 Nm (214 kgf-cm, 15ft-lbf)

EXHAUST MANIFOLD SUB-ASSEMBLY RH






Torque: 21 Nm (214 kgf-cm, 15ft-lbf)

INTAKE MANIFOLD






Torque: 21 Nm (214 kgf-cm, 15ft-lbf)

Flywheel bolts






First Pass: 30 Nm (301 kgf-cm, 22ft-lbf)
Final Pass: + 90 degrees



Crankshaft pulley x Crankshaft
Tightening Torque: 300 Nm (3059 kgf-cm, 221 ft.lbf)

Oil pump x Timing chain cover
Tightening Torque: 10 Nm (102 kgf-cm, 7 ft.lbf)

Cylinder Head Bolt Inspection
Measuring point for intake side bolt: 90 mm (3.54 in.)
Measuring point for exhaust side bolt: 85 mm (3.35 in.)
Standard outside diameter: 10.85 to 11.00 mm (0.427 to 0.433 in.)
Minimum outside diameter: 10.6 mm (0.417 in.)
If the diameter is less than the minimum, replace the cylinder head set bolt.