Installation

DOOR LOCK: ENTRY LOCK AND UNLOCK SWITCH (for Rear Side): INSTALLATION

1. INSTALL REAR DOOR OUTSIDE HANDLE ASSEMBLY

(a) Insert the front end of the rear door outside handle assembly into the rear door outside handle frame.





NOTICE:
If the bellcrank lever is not pulled and held when installing the outside handle, the bellcrank lever will interfere with the outside handle and the release plate will be damaged.

(b) Insert the rear end of the rear door outside handle assembly into the rear door outside handle frame. Next, slide the rear door outside handle assembly toward the front of the vehicle to install it.

(c) Using a "TORX" socket wrench (T30), install the rear door outside handle assembly with the screw.





Torque : 4.0 Nm (41 kgf-cm, 35 in-lbf)

(d) Connect the connector.

2. INSTALL REAR DOOR OUTSIDE HANDLE COVER Reassembly

3. INSTALL REAR DOOR LOCK ASSEMBLY Reassembly

4. INSTALL REAR DOOR GLASS RUN Reassembly

5. INSTALL REAR DOOR GLASS SUB-ASSEMBLY Reassembly

6. INSTALL REAR DOOR QUARTER WINDOW GLASS Reassembly

7. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY Reassembly

8. INSTALL REAR DOOR TRIM BRACKET Reassembly

9. INSTALL REAR DOOR SERVICE HOLE COVER Reassembly

10. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP Reassembly

11. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY Reassembly

12. INSTALL REAR DOOR ARMREST COVER Reassembly

13. INSTALL COURTESY LIGHT ASSEMBLY Reassembly

14. INSTALL REAR DOOR ARMREST BASE PANEL ASSEMBLY Reassembly

15. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG Reassembly