B2002

PRE-COLLISION: PRE-COLLISION SYSTEM: B2002: Open in Seat Belt Motor RH Circuit
B2002 - Open in Seat Belt Motor RH Circuit

DESCRIPTION

The seat belt control ECU receives information from the distance control ECU using CAN communication and tightens the seat by operating the motor in the front seat outer belt RH.

CAUTION:
The pretension is built into the front seat outer belt RH. Be sure to follow the correct inspection procedure, as failure to follow the correct procedure (such as inspection of incorrect connectors) may activate the pretension.





WIRING DIAGRAM

Refer to the DTC B2000 B2000.

INSPECTION PROCEDURE

NOTICE:
When the seat belt control ECU is replaced with a new one, Initialization must be performed Pre-Collision System.

PROCEDURE

1. CHECK WIRE HARNESS (FRONT SEAT OUTER BELT RH - SEAT BELT CONTROL ECU)





(a) Disconnect the cable from the negative (-) battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(b) Disconnect the front seat outer belt RH connector.

(c) Disconnect the seat belt control ECU connector.

(d) Connect the cable to the negative (-) battery terminal.

(e) Using a service wire, connect terminals U8-1 and U8-2 of the connector.

NOTICE:
Do not forcibly insert a service wire into the terminals of the connector when connecting them.

(f) Measure the resistance of the wire harness side connector.

Standard resistance:





(g) Reconnect the seat belt control ECU connector.

(h) Reconnect the front seat outer belt RH connector.

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

2. CHECK FRONT SEAT OUTER BELT ASSEMBLY RH





(a) Disconnect the front seat outer belt RH connector.

(b) Measure the resistance of the belt.

Standard resistance:





(c) Reconnect the front seat outer belt RH connector.

NG -- REPLACE FRONT SEAT OUTER BELT ASSEMBLY RH

OK -- REPLACE SEAT BELT CONTROL ECU