Electronically Controlled Brake System

BRAKE CONTROL: ELECTRONICALLY CONTROLLED BRAKE SYSTEM: DIAGNOSTIC TROUBLE CODE CHART

HINT
* If a trouble code is displayed during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "Refer to" below.
* Inspect the fuses and relays before investigating the trouble areas as shown in the table below.

C0200/31 - C0215/34:

C1235/35 - C1244/44:

C1245/45 - C1442/44 / U0124/95:

HINT
* In some cases, the Techstream cannot be used when ABS warning light remains on.
* When U0073/94, U0293/59, U0123/62, U0124/95, U0126/63, U0130/68 or U0131/67 is output, inspect and repair the trouble areas indicated by these codes first.
* Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed.
* Drive the vehicle at a speed of 50 km/h (31 mph) and depress the brake pedal strongly for approximately 3 seconds.
* Repeat the above operation 3 times or more and check that the ABS warning light goes off.
* Clear the DTCs.