Only Rear Door LH Lock / Unlock Functions Do Not Operate

DOOR LOCK: POWER DOOR LOCK CONTROL SYSTEM: Only Rear Door LH LOCK / UNLOCK Functions do not Operate
- Only Rear Door LH LOCK / UNLOCK Functions do not Operate

DESCRIPTION

The rear multiplex network door ECU LH receives lock/unlock switch signals and activates the door lock motor according to the signals.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. PERFORM ACTIVE TEST USING TECHSTREAM (REAR DOOR LOCK MOTOR)

(a) Select the ACTIVE TEST, use the Techstream to generate a control command, and then check that the door lock motor operates.

Rear Multiple Network Door ECU LH

OK:

Door locks/unlocks.

OK -- REPLACE REAR MULTIPLEX NETWORK DOOR ECU LH
NG -- Continue to next step.

2. INSPECT FUSE (RR DOOR LH)

(a) Remove the RR DOOR LH fuse from the main body ECU LH.

(b) Measure the resistance of the fuse.

Standard resistance:

Below 1 Ohms

NG -- REPLACE FUSE
OK -- Continue to next step.

3. CHECK WIRE HARNESS (ECU - BATTERY AND BODY GROUND)

(a) Disconnect the O7 ECU connector.

(b) Measure the voltage of the wire harness side connector.

Standard voltage:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

4. INSPECT REAR DOOR LOCK ASSEMBLY LH

(a) Apply battery voltage to the door lock motor and check operation of the door lock motor.

OK:

NG -- REPLACE REAR DOOR LOCK ASSEMBLY LH
OK -- Continue to next step.

5. READ VALUE USING TECHSTREAM (DOOR LOCK POSITION SWITCH)

(a) Check the DATA LIST for proper functioning of the door lock position switch.

Rear Multiple Network Door ECU LH

OK:

ON (rear door LH side door is unlocked) appears on screen.

OK -- REPLACE REAR MULTIPLEX NETWORK DOOR ECU LH
NG -- Continue to next step.

6. INSPECT REAR DOOR LOCK ASSEMBLY LH (DOOR LOCK POSITION SWITCH)

(a) Measure the resistance of the switch.

Standard resistance:

NG -- REPLACE REAR DOOR LOCK ASSEMBLY LH
OK -- Continue to next step.

7. CHECK WIRE HARNESS (ECU - DOOR LOCK)

(a) Disconnect the O8 ECU connector.

(b) Disconnect the O10 door lock connector.

(c) Measure the resistance of the wire harness side connectors.

Standard resistance:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR

OK -- REPLACE REAR MULTIPLEX NETWORK DOOR ECU LH