Front Axle Hub

AXLE: FRONT AXLE HUB: ON-VEHICLE INSPECTION

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.
1. REMOVE FRONT WHEEL

2. REMOVE FRONT DISC BRAKE CALIPER ASSEMBLY LH Removal

3. REMOVE FRONT DISC Disassembly

4. INSPECT FRONT AXLE HUB BEARING LOOSENESS

(a) Using a dial indicator, measure the looseness near the center of the axle hub.





Maximum:

0.05 mm (0.0020 in.)

NOTICE:
Ensure that the dial indicator is set at a right angle to the measurement surface.

(a) If the looseness exceeds the maximum, replace the axle hub.

5. INSPECT FRONT AXLE HUB RUNOUT

(a) Using a dial indicator, measure the runout on the surface of the axle hub outside the hub bolt.





Maximum:

0.05 mm (0.0020 in.)

NOTICE:
Ensure that the dial indicator is set at a right angle to the measurement surface.

(a) If the runout exceeds the maximum, replace the axle hub.

6. INSTALL FRONT DISC Reassembly

7. INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY LH Installation

8. INSTALL FRONT WHEEL