Installation

2GR-FSE FUEL: INJECTOR DRIVER: INSTALLATION

1. INSTALL INJECTOR DRIVER

NOTICE:
* Be careful not to drop or strike the injector driver.
* The injector driver is grounded at the bolt and nut. To ensure that it is grounded, clean all oil and foreign matter from the installation areas of the injector driver and engine before installing the injector driver.
(a) Install the injector driver with the bolt and 2 nuts.





Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(b) Connect the 4 injector driver connectors.





(1) Connect the 3 connectors with wire harness locks and the connector to the injector driver. Move the lock lever in the direction indicated by the arrow to lock the connector.

NOTICE:
Connect the connector securely.

2. INSTALL NO. 1 ENGINE COVER

(a) Install the cover with the 3 clips.





(b) Connect the 4 connectors.

3. INSTALL AIR CLEANER INLET

(a) Install the air cleaner inlet with the bolt.





Torque : 5.0 Nm (51 kgf-cm, 44 in-lbf)

4. INSTALL COOL AIR INTAKE DUCT SEAL Installation

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

6. INSTALL SERVICE PLUG GRIP Installation

7. PERFORM INITIALIZATION

(a) Perform initialization Repair Instruction - Initialization.

NOTICE:
Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.