Installation

BRAKE CONTROL: BRAKE PEDAL STROKE SENSOR: INSTALLATION

1. INSTALL BRAKE PEDAL STROKE SENSOR ASSEMBLY

(a) When installing a new brake pedal stroke sensor assembly:

(1) Install a new sensor with the 2 nuts.

Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)

NOTICE:
* Engage the sensor lever with the brake pedal groove.
* Check that there is no foreign matter attached to the sensor's contacting surface.
(2) Firmly depress the brake pedal and break the sensor lever set pin.

(3) Remove the broken sensor lever set pin.

(4) Connect the sensor connector.

(b) When reusing the brake pedal stroke sensor assembly:

(1) Temporarily install the sensor with the 2 nuts.





NOTICE:
* Engage the sensor lever with the brake pedal groove.
* Check that there is no foreign matter attached to the sensor's contacting surface.
(2) Connect the sensor connector.

(3) Connect the cable to the negative battery terminal.

(4) Connect the Techstream to the DLC3.

(5) Turn the power switch ON (IG). Reading the stroke sensor value shown on the data monitor, turn the sensor slowly to the right and left to adjust the output voltage to the standard voltage.

Standard voltage:

0.8 to 1.2 V





(6) Disconnect the cable from the negative battery terminal.

(7) Tighten the 2 nuts.

Torque : 8.5 Nm (86 kgf-cm, 75 in-lbf)

NOTICE:
Do not depress the brake pedal after turning the power switch ON (IG).

2. INSTALL DRIVER SIDE KNEE AIRBAG ASSEMBLY Installation

3. INSTALL NO. 1 INSTRUMENT PANEL SAFETY PAD SUB ASSEMBLY Installation

4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

5. INSTALL INSTRUMENT SIDE PANEL LH Installation

6. INSTALL FRONT DOOR OPENING TRIM COVER LH Installation

7. INSTALL FRONT DOOR SCUFF PLATE LH Installation

8. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation

9. INSTALL CONSOLE UPPER PANEL ASSEMBLY Installation

10. INSTALL FRONT CONSOLE UPPER PANEL GARNISH Installation

11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

12. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.

13. CHECK AND CLEAR DTC

(a) Check and clear the DTCs Reading and Clearing Diagnostic Trouble Codes.