Installation

AUDIO / VISUAL: RADIO RECEIVER: INSTALLATION

1. INSTALL RADIO RECEIVER ASSEMBLY

2. INSTALL DISPLAY AND NAVIGATION MODULE DISPLAY ASSEMBLY

(a) Install the display and navigation module display assembly as shown in the illustration.





3. INSTALL NO. 2 RADIO BRACKET

(a) Install the No. 2 radio bracket with the 5 screws.

Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)

4. INSTALL NO. 1 RADIO BRACKET

(a) Install the No. 1 radio bracket with the 5 screws.

Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)

5. INSTALL DISPLAY AND NAVIGATION MODULE DISPLAY WITH RADIO RECEIVER ASSEMBLY

(a) Connect each connector.

(b) Engage the 2 clips and install the display and navigation module display with radio receiver assembly.





(c) Install the 4 bolts.

Torque : 13 Nm (128 kgf-cm, 9 ft-lbf)

(d) Remove the protective tape.

6. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation

7. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation

8. INSTALL CONSOLE UPPER PANEL ASSEMBLY Installation

9. INSTALL FRONT CONSOLE UPPER PANEL GARNISH Installation

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL (w/ Navigation System for HDD)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.