Installation

SEAT: LUMBAR SUPPORT ADJUSTER ASSEMBLY: INSTALLATION

HINT
* Use the same procedures for the LH and RH side.
* A bolt without a torque specification is shown in the standard bolt chart. Standard Bolt - Specified Torque For Standard Bolts
1. INSTALL LUMBAR SUPPORT ADJUSTER ASSEMBLY

(a) Install the lumbar support adjuster with the 2 screws.

(b) Connect the connector.

2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

(a) Install the seatback cover (with pad) to the seat frame.

(b) Install the 2 headrest supports.

(c) Fully cover the airbag with the 2 seatback cover brackets and tighten the nut.

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

CAUTION:
* For vehicles with side airbags, the seatback cover must be securely installed. Otherwise, the side airbags may not deploy properly.
* Make sure that the strap is not twisted after installing the bracket.
* Install the bracket securely.
(d) Using hog ring pliers, install the seatback cover (with pad) to the seat frame with new hog rings, and attach the hooks.





(e) Install the front seatback cover inner and outer with the 4 bolts.

3. INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY Reassembly

4. INSTALL FRONT SEAT CUSHION SHIELD INNER Reassembly

5. INSTALL FRONT SEAT CUSHION SHIELD WITH NO. 1 CUSHION SHIELD INNER Reassembly

6. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

7. INSTALL RECLINING POWER SEAT SWITCH KNOB

8. INSTALL FRONT SEAT INNER BELT ASSEMBLY Installation

9. INSTALL FRONT SEAT ASSEMBLY Installation

10. INSTALL FRONT SEAT TRACK REAR INNER COVER Installation

11. INSTALL FRONT SEAT TRACK REAR OUTER COVER Installation

12. INSTALL FRONT SEAT TRACK BRACKET COVER Installation

13. CONNECT FRONT SEAT OUTER BELT ASSEMBLY Installation

14. INSTALL SEAT BELT ANCHOR COVER CAP Installation

15. INSPECT FRONT SEAT ASSEMBLY Installation

16. INSPECT SRS WARNING LIGHT

Inspect SRS warning light Diagnosis System.