Reassembly

PARKING BRAKE: PARKING BRAKE ASSEMBLY: REASSEMBLY

1. INSTALL PARKING BRAKE ANCHOR BLOCK

(a) Install the parking brake anchor block with 2 nuts.





Torque : 76 Nm (775 kgf-cm, 56 ft-lbf)

(b) Install the rear axle hub and bearing assembly Installation.

2. APPLY HIGH TEMPERATURE GREASE

(a) Apply a thin layer of high temperature grease to the area where the parking brake plate contacts the parking brake shoe Removal and Replacement.

3. INSTALL PARKING BRAKE SHOE LEVER

(a) Apply a thin layer of high temperature grease to the area where the parking brake shoe lever contacts the parking brake anchor block.





(b) Install the parking brake shoe lever to the parking brake cable assembly.

NOTICE:
Take care to install the correct parking brake shoe lever because the direction of the pin is different between left and right.

4. INSTALL PARKING BRAKE NO.2 SHOE ASSEMBLY

(a) Using SST, install the parking brake No.2 shoe assembly with the shoe hold down spring No.1 cup, compression No.1 spring and shoe hold down spring No.1 pin.

SST : 09718-00010

HINT
Use the service hole to retain the shoe hold down spring No.1 pin with your finger.





5. INSTALL PARKING BRAKE NO.1 SHOE ASSEMBLY

(a) Using SST, install the parking brake No.1 shoe assembly with the shoe hold down spring No.1 cup, compression No.1 spring and shoe hold down spring No.1 pin.

SST : 09718-00010





6. INSTALL PARKING BRAKE SHOE ADJUSTING SCREW SET

(a) Apply high temperature grease to the thread and all joining areas of the parking brake shoe adjusting screw set.





(b) Install the parking brake shoe adjusting screw set.





7. INSTALL PARKING BRAKE SHOE RETURN NO.1 SPRING

(a) Install the parking brake shoe return No.1 spring.





8. INSTALL PARKING BRAKE SHOE RETURN NO.2 SPRING

(a) Install the parking brake shoe return No.2 spring.





9. CHECK PARKING BRAKE INSTALLATION

(a) Make sure that all the parts are installed properly.

If necessary, reinstall properly.





10. INSTALL REAR DISC

(a) Align the matchmarks on the rear disc and rear axle hub.

11. ADJUST PARKING BRAKE SHOE CLEARANCE Adjustments

12. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

(a) Install the rear disc brake caliper assembly with new 2 bolts and 2 new caliper No.1 plates.

Torque : 65 Nm (663 kgf-cm, 48 ft-lbf)

NOTICE:
* Do not twist the brake hose.
* Make sure that the bolts are free from damage and foreign matter.
* Do not overtighten the bolts.





13. INSTALL REAR WHEEL

Torque : 103 Nm (1,050 kgf-cm, 76 ft-lbf)

14. INSPECT PARKING BRAKE PEDAL TRAVEL Adjustments

15. ADJUST PARKING BRAKE PEDAL TRAVEL Adjustments