Driver Side Seat Belt Warning Light Does Not Operate

METER: METER / GAUGE SYSTEM: Driver Side Seat Belt Warning Light does not Operate
- Driver Side Seat Belt Warning Light does not Operate

DESCRIPTION

When the engine switch on (IG), the center airbag sensor communicates the status of the front seat inner belt (driver side) to the combination meter using the BEAN line. when the seat belt is unfastened, the combination meter flashes the driver side seat belt warning light on the combination meter. When the seat belt is fastened, the combination meter stops flashing the warning light.

WIRING DIAGRAM







PROCEDURE

1. CHECK SUPPLEMENTAL RESTRAINT SYSTEM

(a) Check for supplemental restraint system (SRS) DTCs.

Result:





B -- GO TO SUPPLEMENTAL RESTRAINT SYSTEM
A -- Continue to next step.

2. PERFORM ACTIVE TEST USING TECHSTREAM (DRIVER SIDE SEAT BELT)

(a) Connect Techstream to the DLC3.

(b) Engine switch on (IG).

(c) Turn the tester ON.

(d) Enter following menus: Body Electrical / Combination Meter / Active Test.

(e) Check the operation by referring to the table below.

Combination Meter:





OK -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY
NG -- Continue to next step.

3. INSPECT INSTRUMENT CLUSTER FINISH PANEL (SEAT BELT WARNING LIGHT FOR DRIVER SIDE)

(a) Remove the panel sub-assembly.

(b) Apply battery voltage and check that the seat belt warning light illuminates.





OK:





HINT
When the battery's negative (-) lead is applied to terminal 11 and the positive (+) lead is applied to terminal 6, the seat belt warning light does not illuminate.

NG -- REPLACE INSTRUMENT CLUSTER FINISH PANEL

OK -- REPLACE COMBINATION METER