Installation

LIGHTING: HEADLIGHT ASSEMBLY: INSTALLATION

HINT
* Use the same procedures for the RH side and LH side.
* The procedures listed below are for the LH side.
1. INSTALL LIGHT CONTROL ECU

(a) Attach the claw and install the light control ECU.

(b) Install the 4 screws with the cover.

2. INSTALL FRONT SIDE MAKER LIGHT BULB SOCKET

(a) Install the front side maker light bulb to the front side maker light socket.

3. INSTALL FRONT SIDE MAKER LIGHT BULB

(a) Turn the front side maker light bulb socket and the front side maker light bulb in the direction indicated by the arrow and install as a unit.

4. INSTALL CLEARANCE LIGHT BULB SOCKET

(a) Install the clearance light bulb to the clearance light socket.

5. INSTALL CLEARANCE LIGHT BULB

(a) Turn the clearance light bulb socket and the clearance light bulb in the direction indicated by the arrow and install as a unit.

6. INSTALL FRONT TURN SIGNAL LIGHT BULB SOCKET

(a) Install the font turn signal light bulb to the front turn signal light socket.

7. INSTALL FRONT TURN SIGNAL LIGHT BULB

(a) Turn the front turn signal light bulb socket and the front turn signal light bulb in the direction indicated by the arrow and install as a unit.

8. INSTALL NO. 2 HEADLIGHT BULB

(a) Turn the headlight No. 2 bulb in the direction indicated by the arrow and install it.

9. INSTALL HIGH-INTENSITY DISCHARGE HEADLIGHT BULB

(a) Turn the back cover in the direction indicated by the arrow and install it.

10. INSTALL NO. 1 HEADLIGHT BACK COVER

(a) Turn the headlight back cover No. 1 in the direction indicated by the arrow and install it.

11. INSTALL FRONT BUMPER SIDE SUPPORT

(a) Install the 3 screws with the bumper side support.

12. INSTALL HEADLIGHT ASSEMBLY

(a) Attach the claw and install the 3 bolts with the headlight.

(b) w/ headlight cleaner:

Connect the hose.

(c) Connect the connector as shown in the illustration.

13. INSTALL ENGINE ROOM SIDE COVER Installation

14. INSTALL FRONT BUMPER ASSEMBLY Installation

15. INSTALL COOL AIR INTAKE DUCT SEAL Installation

16. CONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

17. PERFORM INITIALIZATION

Some systems need initialization when disconnecting the cable from the negative battery terminal.

Repair Instruction - Initialization

18. INSPECT SRS WARNING LIGHT

19. VEHICLE PREPARATION FOR HEADLIGHT AIM ADJUSTMENT Adjustments

20. HEADLIGHT AIMING ADJUSTMENT (LOW BEAM) Adjustments

21. HEADLIGHT AIMING ADJUSTMENT (HIGH BEAM) Adjustments