Ignition Relay: Testing and Inspection

1UR-FSE ENGINE CONTROL SYSTEM: IGNITION RELAY NO. 2: ON-VEHICLE INSPECTION

1. REMOVE COOL AIR INTAKE DUCT SEAL Removal

2. REMOVE ENGINE ROOM SIDE COVER LH Removal

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. REMOVE IGNITION RELAY NO. 2 (IG2)

(a) Remove the ignition relay No. 2 from the engine room No. 2 relay block.

5. INSPECT IGNITION RELAY NO. 2

(a) Measure the resistance according to the value(s) in the table below.





Standard resistance:





(a) If the result is not as specified, replace the relay.

6. INSTALL IGNITION RELAY NO. 2

7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

8. INSTALL ENGINE ROOM SIDE COVER LH Installation

9. INSTALL COOL AIR INTAKE DUCT SEAL Installation