Installation

1UR-FSE IGNITION: IGNITION COIL AND SPARK PLUG: INSTALLATION

1. INSTALL SPARK PLUG

(a) Using a 16 mm plug wrench, install the 8 spark plugs.

Torque : 21 Nm (214 kgf-cm, 15 ft-lbf)

2. INSTALL IGNITION COIL ASSEMBLY

(a) Perform a visual inspection on the spark plug tube gasket.

Standard:

(b) Slide the spark plug tube gasket onto the ignition coil as shown in the illustration.

(d) Install the 8 bolts.

Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)

(e) Connect the 8 ignition coil connectors.

3. INSTALL WIRE HARNESS CLAMP BRACKET

(a) Install the bolt, wire harness clamp bracket and wire harness clamp.

Torque : 8.5 Nm (87 kgf-cm, 75 in-lbf)

(b) Install the 2 wire harness clamps.

4. INSTALL NO. 1 ENGINE ROOM RELAY BLOCK ASSEMBLY

(a) Install the 2 bolts and nut.

Bolt - Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

Nut - Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

5. INSTALL BATTERY TRAY

(a) Install the battery tray with the 2 bolts.

Torque : 5.4 Nm (55 kgf-cm, 47 in-lbf)

6. INSTALL POWER STEERING ECU ASSEMBLY Installation

7. INSTALL NO. 1 BATTERY TRAY SUPPORT

8. INSTALL BATTERY Installation

9. INSTALL SKID CONTROL ECU ASSEMBLY Installation

10. INSTALL AIR CLEANER CAP SUB-ASSEMBLY Installation

11. INSTALL NO. 1 AIR CLEANER INLET Installation

12. INSTALL ENGINE ROOM SIDE COVER RH Installation

13. INSTALL ENGINE ROOM SIDE COVER LH Installation

14. INSTALL COOL AIR INTAKE DUCT SEAL Installation

15. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

17. PERFORM INITIALIZATION

(a) Some systems need initialization when disconnecting the cable from the negative battery terminal Repair Instruction - Initialization.