Removal

1UR-FSE ENGINE CONTROL SYSTEM: ECM: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE COOL AIR INTAKE DUCT SEAL Removal

3. REMOVE ENGINE ROOM SIDE COVER LH Removal

4. REMOVE V-BANK COVER SUB-ASSEMBLY Removal

5. REMOVE ENGINE ROOM ECU COVER

(a) Remove the 3 bolts and engine room ECU cover.

NOTICE:
* Wipe off any water on or around the engine room ECU cover.
* Perform this step in a dry place away from rain, etc.
* Do not allow water to enter the ECM through its connectors, screws, etc.
6. DISCONNECT WIRE HARNESS

(a) Detach the claw and disconnect the No. 4 connector holder.





(b) Disconnect the 6 ECM connectors.





7. REMOVE ECM

(a) Remove the 2 nuts and ECM.