Installation

SUSPENSION: REAR STABILIZER BAR: INSTALLATION

1. INSTALL REAR STABILIZER BAR

(a) Insert the rear stabilizer bar between the rear suspension member and exhaust tailpipe assembly so that the oval holes are on the right of the vehicle.





(b) Install the rear stabilizer bar with the 4 bolts in order from 1 to 4.





Torque : 32 Nm (326 kgf-cm, 24 ft-lbf)

2. INSTALL REAR STABILIZER LINK ASSEMBLY LH

(a) Install the stabilizer link assembly LH to the rear suspension No. 2 arm and load sensing valve sensor bracket with the bolt and nut.





Torque : 27 Nm (275 kgf-cm, 20 ft-lbf)

(b) Install the rear stabilizer link assembly LH with the nut.

Torque : 89 Nm (908 kgf-cm, 66 ft-lbf)

NOTICE:
Be sure to hold the stud bolt using a hexagon wrench 6 in order to prevent it from turning.

3. INSTALL REAR STABILIZER LINK ASSEMBLY RH

HINT
Use the same procedures for the RH side and LH side.

4. INSTALL DIFFERENTIAL NO. 2 SUPPORT PROTECTOR Installation

5. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

6. VEHICLE PREPARATION FOR HEADLIGHT AIM ADJUSTMENT Adjustments

7. HEADLIGHT AIMING ADJUSTMENT (LOW BEAM) Adjustments

8. HEADLIGHT AIMING ADJUSTMENT (HIGH BEAM) Adjustments