Instruments - Compass Calibration Procedure

L-SB-0084-09

July 15, 2009

Initial Calibration of Compass During PDS

Service Category
General

Section
Pre-Delivery Service

Market
USA





Applicability

Introduction





Some 2010 model HS250h vehicles are equipped with a compass in the rear view mirror. In order for the compass to correctly indicate the direction that the vehicle is heading it must be calibrated prior to vehicle delivery. Use the appropriate procedure (depending on mirror type) to perform initial calibration during Pre-Delivery Service (PDS).





Warranty Information

Type A





1. Cycle the ignition switch to the "IG-ON" position and hold the "N" switch until the zone number appears on the display.

HINT

Pushing the "N" switch turns ON or OFF the compass display

2. Push the "N" switch to select the number of the zone where the vehicle is located.





See the map in figure 3 for zone reference.





3. Start the engine and push the "N" switch until "CAL" appears on the display.

Type B





1. Cycle the ignition switch to the "IG-ON" position and hold the "AUTO" switch for 6 seconds until the zone number appears on the display.

HINT

Pushing the "AUTO" switch for 3 seconds turns ON or OFF the compass display.

2. Push the "AUTO" switch to select the number of the zone where the vehicle is located.





See the map in figure 6 for zone reference.





3. Start the engine and push the "AUTO" switch for about 9 seconds until "C" appears on the display.