B2786

MULTIPLEX COMMUNICATION: LIN COMMUNICATION SYSTEM: B2786: No Response from Steering Lock ECU
B2786 - No Response from Steering Lock ECU

DESCRIPTION

This DTC is output when LIN communication between the certification ECU and steering lock actuator assembly (steering lock ECU) stops for 10 seconds or more.

WIRING DIAGRAM

INSPECTION PROCEDURE

NOTICE:
When using the Techstream with the power switch OFF to troubleshoot:

Connect the Techstream to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.

HINT
DTC B2785 is output when the communication between all of the following components and certification ECU stops.

PROCEDURE

1. CLEAR DTC

(a) Clear the DTC Reading and Clearing Diagnostic Trouble Codes.

NEXT -- Continue to next step.

2. CHECK FOR DTC

(a) Recheck for DTC Reading and Clearing Diagnostic Trouble Codes.

Result

B -- USE SIMULATION METHOD TO CHECK How To Proceed With Troubleshooting
A -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - STEERING LOCK ECU)

(a) Disconnect the L15 and L33 ECU connectors.

(b) Measure the resistance according to the value(s) in the table below.

Standard resistance:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

4. CHECK HARNESS AND CONNECTOR (STEERING LOCK ECU - BATTERY AND BODY GROUND)

(a) Disconnect the L33 ECU connector.

(b) Measure the resistance and voltage according to the value(s) in the table below.

Standard resistance:

Standard voltage:

NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

5. REPLACE STEERING LOCK ACTUATOR ASSEMBLY

(a) Temporarily replace the steering lock actuator with a new one Disassembly.

(b) Clear the DTC Reading and Clearing Diagnostic Trouble Codes.

NEXT -- Continue to next step.

6. CHECK FOR DTC

(a) Recheck for DTC Reading and Clearing Diagnostic Trouble Codes.

Result

B -- REPLACE CERTIFICATION ECU Removal

A -- END (STEERING LOCK ECU IS DEFECTIVE)