C1246

BRAKE CONTROL: ELECTRONICALLY CONTROLLED BRAKE SYSTEM: C1246/46,C1281/81,C1364/61: Master Cylinder Pressure Sensor Malfunction


DESCRIPTION

The master cylinder pressure sensor and the wheel cylinder pressure sensor are built into the brake actuator. They measure the master cylinder pressure and wheel cylinder pressure and send the data to the skid control ECU.

DTC C1281/81 can be deleted when the master cylinder pressure sensor sends a master cylinder pressure signal or the Test Mode ends. DTC C1281/81 is output only in the Test Mode.













WIRING DIAGRAM





INSPECTION PROCEDURE

NOTICE:
- When replacing the skid control ECU, perform the following operations:
* Initialization of linear solenoid valve and calibration Initialization
* Yaw rate and acceleration sensor zero point calibration Calibration
- When replacing the brake actuator, perform initialization of the linear solenoid valve and calibration Initialization.

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (SKID CONTROL ECU - BRAKE ACTUATOR)

(a) Disconnect the A19 and A21 ECU connectors.

(b) Disconnect the A27 actuator connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

2. READ VALUE USING TECHSTREAM (MASTER CYLINDER PRESSURE SENSOR)

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch ON (IG).

(c) Select the Data List mode on the Techstream.

ABS/VSC/TRAC:





(d) Check the output value of the master cylinder pressure sensor on the Techstream display.

OK:

When the pedal is depressed, the voltage displayed on the Techstream increases.

NG -- REPLACE BRAKE ACTUATOR Removal
OK -- Continue to next step.

3. CHECK PRESSURE SENSOR OPERATION

(a) Check the pressure sensor operation On-Vehicle Inspection.

NG -- REPLACE BRAKE ACTUATOR Removal
OK -- Continue to next step.

4. RECONFIRM DTC

(a) Clear the DTC Reading and Clearing Diagnostic Trouble Codes.

(b) Perform the road and braking test.

(c) Check if the same DTCs are recorded Reading and Clearing Diagnostic Trouble Codes.

HINT
Reinstall the sensors, connectors, etc. and restore the vehicle to its prior condition before rechecking for DTCs.

Result





B -- USE SIMULATION METHOD TO CHECK How To Proceed With Troubleshooting
A -- Continue to next step.

5. CHECK FREEZE FRAME DATA

(a) Check the information code from the "FREEZE FRAME DATA" memorized when the DTCs (C1246/46 and C1364/61) are stored Freeze Frame Data.

Result





B -- REPLACE BRAKE ACTUATOR Removal

A -- REPLACE SKID CONTROL ECU Removal