C13AE

PARKING BRAKE: ELECTRIC PARKING BRAKE SYSTEM: C13AE/72: System information not Received
C13AE/72 - System information not Received

DESCRIPTION





INSPECTION PROCEDURE

NOTICE:
If the electric parking brake ECU or electric parking brake actuator is replaced, perform the "RESET MEMORY" and "ACQUIRE TENSION SENSOR ZERO POINT" procedures Programming and Relearning.

PROCEDURE

1. CHECK DTC

(a) Turn the power switch OFF.

(b) Connect the Techstream to the DLC3.

(c) Turn the power switch ON (IG) and the Techstream on.

(d) Check for DTC Reading and Clearing Diagnostic Trouble Codes.

Result





B -- USE SIMULATION METHOD TO CHECK How To Proceed With Troubleshooting
A -- Continue to next step.

2. CLEAR DTC

(a) Turn the power switch OFF.

(b) Connect the Techstream to the DLC3.

(c) Turn the power switch ON (IG) and the Techstream on.

(d) Clear the DTC Reading and Clearing Diagnostic Trouble Codes.

NEXT -- Continue to next step.

3. CHECK DTC

(a) Drive the vehicle at 30 km/h (19 mph) or more for 5 seconds or more.

(b) Turn the power switch OFF.

(c) Connect the Techstream to the DLC3.

(d) Turn the power switch ON (IG) and the Techstream on.

(e) Check for DTC Reading and Clearing Diagnostic Trouble Codes.

Result





B -- REPLACE ELECTRIC PARKING BRAKE ECU Removal

A -- GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) How to Proceed With Troubleshooting