P3176

L110F HYBRID VEHICLE CONTROL: HYBRID CONTROL SYSTEM: P3176-863: Transmission Oil Pump Motor Coil Temperature Sensor Circuit Low
P3176-863 - Transmission Oil Pump Motor Coil Temperature Sensor Circuit Low

DESCRIPTION

The resistance of the temperature sensor (thermistor) installed in the oil pump motor changes in accordance with changes in the oil pump motor temperature. The lower the oil pump motor temperature, the higher the temperature sensor (thermistor) resistance. Conversely, the higher the temperature, the lower the resistance. The oil pump motor temperature sensor (thermistor) is connected to the hybrid vehicle control ECU. A power source voltage of 5 V is supplied to the oil pump motor temperature sensor (thermistor) through terminal TOPM of the hybrid vehicle control ECU. This means that resistor R in the ECU and the oil pump motor temperature sensor (thermistor) are connected in series. The voltage at terminal TOPM and the resistance value change in accordance with changes in the oil pump motor temperature.





WIRING DIAGRAM





INSPECTION PROCEDURE

HINT
The characteristics of the oil pump motor temperature sensor resistance (reference values) are as follows:





PROCEDURE

1. CLEAR DTC

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.

(d) Read and record the DTCs and freeze frame data.

(e) Select the following menu items: Powertrain / Hybrid Control / Trouble Codes.

(f) Clear DTCs and freeze frame data.

NEXT -- Continue to next step.

2. READ VALUE USING TECHSTREAM (OPM TEMPERATURE)

(a) Select the following menu items: Powertrain / Hybrid Control / Data List / OPM Temperature.

(b) Read the data list.

Result:





B -- CHECK FOR INTERMITTENT PROBLEMS Check For Intermittent Problems
A -- Continue to next step.

3. CHECK HARNESS AND CONNECTOR

(a) Turn the power switch off.





(b) Disconnect connectors A74 and E55 from the hybrid vehicle control ECU.

(c) Measure the resistance according to the value(s) in the table below.

Standard resistance (Check for short):





Standard resistance:





NG -- CHECK OIL WITH MOTOR PUMP ASSEMBLY (OIL PUMP MOTOR TEMPERATURE SENSOR)

OK -- REPLACE HYBRID VEHICLE CONTROL ECU Components

4. CHECK OIL WITH MOTOR PUMP ASSEMBLY (OIL PUMP MOTOR TEMPERATURE SENSOR)

(a) Turn the power switch off.





(b) Disconnect the oil pump motor temperature sensor connector.

(c) Measure the resistance according to the value(s) in the table below.





Standard resistance (Check for short):





(d) Measure the resistance according to the value(s) in the table below.

Standard resistance:





NG -- REPLACE OIL WITH MOTOR PUMP ASSEMBLY Components

OK -- REPAIR OR REPLACE HARNESS OR CONNECTOR