Removal

MIRROR: INNER REAR VIEW MIRROR: REMOVAL

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Removal

2. REMOVE BATTERY SERVICE HOLE COVER LH Removal

3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
* After the power switch is turned OFF, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch OFF, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
4. REMOVE MAP LIGHT ASSEMBLY Removal

5. REMOVE RAIN SENSOR COVER





(a) Pull the stopper in the direction shown in the illustration.

(b) Detach the 2 claws and remove the rain sensor cover.

6. REMOVE RAIN SENSOR COVER (w/ Driver Monitor Camera)





NOTICE:
When removing the rain sensor cover, do not apply force to the object recognition camera areas labeled "X".





(a) Pull the stopper in the direction shown in the illustration.

(b) While being careful not to apply force to the camera areas, detach the 2 clips and 2 claws and remove the rain sensor cover.

7. REMOVE INNER REAR VIEW MIRROR ASSEMBLY (w/o Automatic High Beam System)

(a) Disconnect the connector.

(b) Using a T20 "TORX" socket wrench, remove the screw and inner rear view mirror.





8. REMOVE INNER REAR VIEW MIRROR ASSEMBLY (w/ Automatic High Beam System)

NOTICE:
* Do not touch of the camera lens (built into the inner rear view mirror assembly) with a bare hand.
* Do not allow anything to adhere to the camera lens (built into the inner rear view mirror assembly).
* Do not apply strong impact to the inner rear view mirror assembly.
* Do not allow any liquids to get on the inner rear view mirror assembly.
(a) Disconnect the connector.

(b) Using a T20 "TORX" socket wrench, remove the screw and inner rear view mirror.