Removal

L110F HYBRID TRANSMISSION / TRANSAXLE: SHIFT LEVER POSITION SENSOR: REMOVAL

1. REMOVE LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Removal

2. REMOVE DECK TRIM SIDE BOARD LH (w/o Spare Tire) Removal

3. REMOVE BATTERY SERVICE HOLE COVER LH Removal

4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.
* After the power switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and settings. As a result, after turning the power switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery terminal.
5. REMOVE FRONT FLOOR COVER CENTER Removal

6. REMOVE NO. 2 ENGINE UNDER COVER Removal

7. SEPARATE OIL COOLER TUBE

(a) Remove the 3 bolts and separate the oil cooler tube.

8. SEPARATE FLOOR SHIFT GEAR SHIFTING ROD SUB-ASSEMBLY

(a) Set the shift lever to the neutral position.

(b) Remove the nut, and separate the floor shift gear shifting rod sub-assembly.

9. REMOVE PARK/NEUTRAL POSITION SWITCH

(a) Disconnect the park/neutral position switch connector.

(b) Remove the nut, washer and transmission control shaft lever.

(d) Remove the lock nut and lock washer.

(e) Remove the 2 bolts and park/neutral position switch.