Operation CHARM: Car repair manuals for everyone.

Installation





SUSPENSION CONTROL: REAR ACTIVE STABILIZER CONTROL ECU: INSTALLATION

1. INSTALL BRACKET

(a) Install the bracket with the 4 screws.





Torque : 3.0 Nm (31 kgf-cm, 27 in-lbf)

2. INSTALL REAR ACTIVE STABILIZER CONTROL ECU





(a) Connect the ECU connector.

(1) Connect the ECU connector. (*1)

(2) Rotate the lever in the direction of the arrow until a "click" sound is heard. (*2)

(3) Lock the lever's lock. (*3)

(b) Connect the shielded ground wire connector.





(c) Install the ECU with the 2 bolts.

Torque : 14 Nm (138 kgf-cm, 10 ft-lbf)

3. CONNECT REAR ACTIVE STABILIZER CONTROL ACTUATOR CONNECTOR





(a) Connect the actuator connector labeled A.

(b) Connect the actuator connector labeled B.

(1) Connect the actuator connector. (*1)

(2) Rotate the lever in the direction of the arrow until a "click" sound is heard. (*2)

(3) Lock the lever's lock. (*3)





(c) Attach the wire harness clamp.

4. INSTALL LUGGAGE COMPARTMENT TRIM COVER ASSEMBLY LH Installation

5. INSTALL REAR FLOOR FINISH PLATE Installation

6. INSTALL TOOL BOX (w/o Spare Tire) Installation

7. INSTALL DECK BOARD ASSEMBLY (w/o Spare Tire)

8. INSTALL FRONT LUGGAGE COMPARTMENT TRIM COVER Installation

9. INSTALL NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY Installation

10. INSTALL NO. 1 COOLER COVER (w/ Air Conditioning System) Installation

11. INSTALL ROPE HOOK ASSEMBLY Installation

12. INSTALL ROPE HOOK Installation

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.6 Nm (57 kgf-cm, 50 in-lbf)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

14. INSTALL BATTERY SERVICE HOLE COVER LH Installation

15. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Installation

16. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light Diagnosis System.