Dynamic Radar Cruise Control System
CRUISE CONTROL: DYNAMIC RADAR CRUISE CONTROL SYSTEM: C1A10: Front Radar Sensor
C1A10 - Front Radar Sensor
DESCRIPTION
The driving support ECU assembly uses the millimeter wave radar sensor to detect obstacles in front of the vehicle.
When the driving support ECU receives information that there is a malfunction in the millimeter wave radar sensor assembly, DTC C1A10 is stored.
INSPECTION PROCEDURE
NOTICE:
When the millimeter wave radar sensor is replaced with a new one, adjustment of the front sensor beam axis must be performed Adjustments.
PROCEDURE
1. REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY
(a) Replace the millimeter wave radar sensor assembly Removal.
NEXT -- Continue to next step.
2. ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY
(a) Adjust the millimeter wave radar sensor assembly Adjustments.
NEXT -- Continue to next step.
3. CHECK WHETHER DTC OUTPUT RECURS
(a) Connect the Techstream to the DLC3.
(b) Turn the power switch on (IG).
(c) Clear the DTCs Dynamic Radar Cruise Control System.
(d) Perform the following to make sure that the DTC detection conditions are met.
HINT
If the detection conditions are not met, the malfunction cannot be detected.
(1) Drive the vehicle at a speed of 50 km/h (30 mph) and 170 km/h (105 mph).
(2) Turn the cruise control switch (ON-OFF button) on.
(3) Push the -/SET switch to activate the cruise control.
(e) Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.
(f) Read the DTCs.
Result:
B -- REPLACE DRIVING SUPPORT ECU ASSEMBLY Removal
A -- END