Installation

EXTERIOR PANELS / TRIM: WINDSHIELD OUTSIDE MOULDING: INSTALLATION

1. INSTALL WINDSHIELD NO. 1 OUTSIDE MOULDING CLIP

(a) Using an air riveter or a hand riveter with a nose piece, install the 5 windshield No. 1 outside moulding clips with 5 new rivets.





HINT
If the mandrel of the rivet does not come off on the first operation of the rivet gun, slide the rivet gun forward on the mandrel and operate it again.

NOTICE:
* Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.






Text in Illustration





* Confirm that the rivets are seated properly against the roof drip side finish moulding clip.






Text in Illustration





* Do not tilt the riveter when installing the rivet to the roof drip side finish moulding clip.
* Do not leave any clearance between the rivet head and roof drip side finish moulding clip.
* Do not leave any clearance between the roof drip side finish moulding clip and front pillar. Firmly hold the 2 items together while installing the rivet.






Text in Illustration





2. INSTALL WINDSHIELD GLASS

Installation

3. INSTALL WINDSHIELD OUTSIDE MOULDING

(a) Engage the guide and 10 claws to install the windshield outside moulding.





4. INSTALL COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY Installation

5. INSTALL FRONT NO. 2 SIDE PANEL PROTECTOR LH Installation

6. INSTALL FRONT NO. 2 SIDE PANEL PROTECTOR RH Installation

7. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH Installation

8. INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH Installation

9. INSTALL FRONT WIPER ARM HEAD CAP Installation