Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: CENTER AIRBAG SENSOR ASSEMBLY: INSTALLATION

1. INSTALL AIRBAG SENSOR ASSEMBLY

(a) Check that the power switch is off.

(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

(c) Install the airbag sensor assembly with the 3 bolts.





Text in Illustration





Torque : 18 Nm (178 kgf-cm, 13 ft-lbf)

NOTICE:
* If the airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
* When installing the airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
* When the power switch is first turned on (IG) after the airbag sensor assembly has been replaced, make sure that no one is in the vehicle.

(d) Connect the connectors to the airbag sensor assembly as shown in the illustration.





NOTICE:
When connecting any airbag connector, take care not to damage the airbag wire harness.

(e) Check that the waterproof sheet is properly set.

(f) Check that there is no looseness in the installation parts of the airbag sensor assembly.

2. INSTALL NO. 5 DISC PLAYER BRACKET (w/ Navigation System for DVD) Installation

3. INSTALL MULTI-MEDIA MODULE ASSEMBLY (w/ Navigation System for DVD) Installation

4. INSTALL NO. 3 CONSOLE BOX MOUNTING BRACKET (w/ Navigation System for DVD) Installation

5. INSTALL CONSOLE BOX LH Installation

6. INSTALL CONSOLE BOX INSERT Installation

7. INSTALL CONSOLE BOX RH Installation

8. INSTALL FRONT NO. 2 CONSOLE BOX INSERT Installation

9. INSTALL INTEGRATION CONTROL AND PANEL ASSEMBLY Installation

10. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

11. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

Installation

12. INSTALL FRONT CONSOLE BOX

Installation