Installation

SUPPLEMENTAL RESTRAINT SYSTEMS: SEAT POSITION SENSOR: INSTALLATION

1. INSTALL SEAT POSITION AIRBAG SENSOR (for Manual Seat)

(a) Install the seat position airbag sensor to the seat slide position sensor protector with the pin as shown in the illustration.





(b) Using a 1.3 mm (0.0512 in.) feeler gauge, temporarily install the seat position airbag sensor with the "TORX" screw.





Text in Illustration





NOTICE:
* If the seat position airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position airbag sensor with a new one.
* When installing the seat position airbag sensor, be careful that the SRS wiring does not interfere with or is pinched between other parts.

HINT
Be sure that the clearance between the seat position airbag sensor and seat rail is between 0.6 mm (0.0236 in.) and 2.0 mm (0.0787 in.).

(c) Using a T30 "TORX" socket wrench, tighten the "TORX" screw to install the seat position airbag sensor.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(d) Make sure that the clearance between the seat position airbag sensor and seat rail is between 0.6 mm (0.0236 in.) and 2.0 mm (0.0787 in.).

(e) Connect the connector.

(f) Install the wire harness to the 2 hooks.

(g) Check that there is no looseness in the installation parts of the seat position airbag sensor.

2. INSTALL SEAT POSITION AIRBAG SENSOR (for Power Seat)

(a) Install the seat position airbag sensor to the seat slide position sensor protector with the pin as shown in the illustration.





(b) Using a 1.3 mm (0.0512 in.) feeler gauge, temporarily install the seat position airbag sensor with the "TORX" screw and nut.





Text in Illustration





NOTICE:
* If the seat position airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the seat position airbag sensor with a new one.
* When installing the seat position airbag sensor, be careful that the SRS wiring does not interfere with or is pinched between other parts.

HINT
Be sure that the clearance between the seat position airbag sensor and seat rail is between 0.6 mm (0.0236 in.) and 2.0 mm (0.0787 in.).

(c) Using a T30 "TORX" socket wrench, install the seat position airbag sensor with the "TORX" screw and nut.

Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(d) Make sure that the clearance between the seat position airbag sensor and seat rail is between 0.6 mm (0.0236 in.) and 2.0 mm (0.0787 in.).

(e) Connect the connector.

(f) Install the wire harness to the 2 hooks.

(g) Check that there is no looseness in the installation parts of the seat position airbag sensor.

3. INSTALL FRONT SEAT CUSHION SHIELD LH (for Manual Seat) Reassembly

4. INSTALL VERTICAL ADJUSTING HANDLE LH (for Manual Seat) Reassembly

5. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat) Reassembly

6. INSTALL FRONT SEAT ASSEMBLY LH

for Manual Seat: Installation

for Power Seat: Installation