P410 Hybrid Transmission / Transaxle

P410 HYBRID TRANSMISSION / TRANSAXLE: HYBRID TRANSAXLE SYSTEM: ON-VEHICLE INSPECTION

1. INSPECT TRANSAXLE FLUID PRESSURE

NOTICE:
Perform the test at normal operating transaxle fluid temperature 50 to 80°C (122 to 176°F).

(a) Remove the rear engine under cover LH.

(b) Lift up the vehicle.

(c) Remove the fluid pump cover plug and O-ring.

(d) Install an oil pressure gauge with the adapter.





(e) Put the engine in inspection mode Component Tests and General Diagnostics.

(f) Measure the transaxle fluid pressure.

Standard:





NOTICE:
Be sure to cancel inspection mode immediately after the transaxle fluid pressure check is completed.

(g) Install a new O-ring and fluid pump cover plug.





Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(h) Install the rear engine under cover LH.