Installation

AXLE AND DIFFERENTIAL: REAR AXLE HUB: INSTALLATION

HINT
* Use the same procedure for the RH side and LH side.
* The procedure listed below is for the LH side.

1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY

(a) Install the rear axle hub and bearing assembly and rear disc brake dust cover sub-assembly to the rear axle carrier sub-assembly with the 4 bolts.

Torque : 90 Nm (918 kgf-cm, 66 ft-lbf)

2. CONNECT REAR SPEED SENSOR WIRE Installation

3. INSPECT REAR AXLE HUB BEARING LOOSENESS Rear Axle Hub

4. INSPECT REAR AXLE HUB RUNOUT Rear Axle Hub

5. INSTALL REAR DISC Installation

6. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY Replacement

7. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY Installation

8. INSTALL PARKING BRAKE LEVER PROTECTOR Installation

9. INSTALL REAR SUSPENSION ARM COVER Installation

10. ADJUST PARKING BRAKE

Adjustments

11. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY Installation

12. INSTALL INSTRUMENT SIDE PANEL LH Installation

13. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH Installation

14. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Installation

15. INSTALL REAR WHEEL

Torque : 103 Nm (1050 kgf-cm, 76 ft-lbf)

16. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

(a) Connect the cable to the negative (-) battery terminal Battery: Installation.

(b) Connect the reservoir level switch connector.

(c) Clear the DTCs Reading and Clearing Diagnostic Trouble Codes.

17. CHECK FOR SPEED SENSOR SIGNAL

Test Mode Procedure