Installation

EXTERIOR: FRONT BUMPER: INSTALLATION

1. INSTALL FRONT BUMPER ASSEMBLY

(a) Connect each connector.

(b) Engage the 3 claws and install the front bumper assembly as shown in the illustration.





HINT
Use the same procedure for the RH side and LH side.

(c) Install the front bumper assembly with the 9 screws, 2 clips and bolt.





Screw (A) - Torque : 2.0 Nm (20 kgf-cm, 18 in-lbf

(d) Install the 2 pin hold clips.





NOTICE:
Insert the pin hold clip with the slot aligned vertically. Do not rotate the clip after inserting it. After installation, confirm that the slot is vertical.

HINT
Use the same procedure for the RH side and LH side.

2. INSTALL RADIATOR GRILLE PROTECTOR

(a) Install the 2 radiator grille protectors.





3. INSTALL COOL AIR INTAKE DUCT SEAL

(a) Install the cool air intake duct seal with the 7 clips.





4. VEHICLE PREPARATION FOR FOG LIGHT AIM ADJUSTMENT Adjustments

5. PREPARATION FOR FOG LIGHT AIMING Adjustments

6. FOG LIGHT AIMING INSPECTION Adjustments

7. FOG LIGHT AIMING ADJUSTMENT Adjustments